BSE

Torch Cutting Machine (light)

type: BSE

framag's torch cutting machine type BSE is designed for the use in slab discharge areas for cutting of slabs in length and cross direction. Edge detection and cutting to the designated length will be done fully automatically.

The new developed advanced EVOLUTION FCN-nozzle technology guarantees further improvement of the cutting quality and reduces the required cycle time by increased cutting speed. Material loss is minimized and yield increased due to smaller cutting gap.

Material Dimensions

for all dimensions

Material Quality

carbon steel
stainless steel grades

Cutting Speed

up to 500 mm/min
220 mm thickness
850 °C; C_equ = 0,13 %

Benefits

smallest cutting gap by using of framag's new developed "EVOLUTION FCN-Nozzle"
optizmized yield and saving of money
perfect cutting quality and accuracy
highest cutting speed and shortest cycle time
shortest length of cut slabs are possible
lowest gas and oxygen consumption due to minimized cutting cycle time
almost maintenance free operation

Cutting Nozzle EVOLUTION

	FCN 150	FCN 300	FCN 500	FCN 700
material quality	carbon steel	carbon steel	carbon steel	carbon steel
C-Eq	0,04	0,04	0,04	0,04
material temperature (°C)	850	850	850	850
material thickness (mm)	100 / 150	220 / 250	500	700
cutting speed (mm/min)	650 / 570	500 / 450	500 / 450	500 / 450
cutting kerf (mm)	4 - 5	5 - 7	5 - 7	5 - 7

FCN 150 for nominal thickness of 200 mm
FCN 300 for nominal thickness of 350 mm
FCN 500 for nominal thickness of 500 mm
FCN 700 for nominal thickness of 700 mm

data sheet torch cutting machine type BSE

download file data sheet torch cutting machine type BSE - Dateigröße: 171.09 kB

savings due to FCN

download file savings due to FCN - Dateigröße: 581.67 kB

Cutting Nozzle EVOLUTION

Due to the further optimized nozzle technology framag is able to minimize the cutting kerf through the complete range of cutting thicknesses even by improved cutting quality and increased cutting speed. The utility consumption (cutting oxygen, heating gas and oxygen) can be reduced too.

The FCN-cutting nozzle EVOLUTION can be used to cut carbon steel as well as stainless steel grades. Up to a nominal cutting thickness of 200 mm framag advice the FCN 150 while FCN 300 is developed for nominal cutting thicknesses up to 350 mm.

Certificated quality

Our employees are responsible for the quality of our products . The highly trained fitters and welders connect the components according to different standards .

If you want we can issue a special certificate for our welded parts.